cilindru Ordine alfabetică Ezita 12v led with bjt Diplomă foaie volantă da
Simple Circuits and Projects: LED Flasher Using BJT
LED fade on off improved with NPN BJT improved capacitor controlled by push button switch circuit - YouTube
I have a PNP BJT and an LED driver (current sink, theoretically 20 mA and max 3.3 V). The LED driver is connected through an LED to the base of the BJT.
Single Transistor LED Flasher Circuit | Homemade Circuit Projects
Alternating between two LEDS using BJTs - Electrical Engineering Stack Exchange
circuit design - LED Dimmer only using NPN BJT and potentiometer - Electrical Engineering Stack Exchange
How to drive a 10 Watt LED from an Arduino? - Electrical Engineering Stack Exchange
How to Drive a DC Motor with a BJT Transistor - techZorro
microcontroller - BJT Constant current LED driver - Electrical Engineering Stack Exchange
Transistors - SparkFun Learn
Use transistor to control 12v LEDs, schematic help needed - General Electronics - Arduino Forum
Can't turn on 12v lamp with npn transistor - General Electronics - Arduino Forum
I have a PNP BJT and an LED driver (current sink, theoretically 20 mA and max 3.3 V). The LED driver is connected through an LED to the base of the BJT.
Driving an LED using a Transistor
circuit design - LED Dimmer only using NPN BJT and potentiometer - Electrical Engineering Stack Exchange
Saturating a transistor using another transistor - General Electronics - Arduino Forum
How does this BJT transistor work without any connection to its base? - Electrical Engineering Stack Exchange
Dimmer effect (fade) on 12v LED using transistor and Arduino - Electrical Engineering Stack Exchange
How can I limit the current to a led using a BJT when the battery voltage changes? (I know the circuit I designed wouldn't limit it to 30ma and could burn the
Dimmer effect (fade) on 12v LED using transistor and Arduino - Electrical Engineering Stack Exchange
BJT Driving an LED - Above or Below? - Electrical Engineering Stack Exchange
Transistors - SparkFun Learn
When a BJT is being used as a switch to turn on a LED, why does the LED not turn on when the base is short to the ground? - Quora
Using NPN transistor for either load control (LEDs) or digital signal (WS2812) - General Electronics - Arduino Forum